Multiplex WINGSTABI Evolution Mode D'emploi page 32

8. Setting up WINGSTABI EASY Control without a PC
The WINGSTABI Evolution is always delivered with the EasyControl software
as standard. However, this can be changed at any time via the PC or the APP.
This software runs on all WINGSTABI versions and, in contrast to the previous
WINGSTABI, does not require a PC for setup. Consequently, WINGSTABI EASY
Control can be integrated in every model programmed on your transmitter and,
after a short teach-in procedure (which servo does what), be flown.
In the factory default setting, the gyro function is switched off in the EASY
Control software so that a model containing WINGSTABI EASY Control can be
programmed on the respective transmitter - as would normally be the case
without a gyro. Thanks to automatic RC system recognition, almost all RC
equipment with a serial signal output at the receiver (Multiplex SRXL, HiTEC
SL, Jeti EXBUS, Futaba S.BUS, Graupner HOTT, JR XBUS Mode B, PPM, CORE
SRXL, S.BUS) is suitable. WINGSTABI with integrated receiver is the best solu-
tion for M-LINK users.
If the smaller scope of system-related functions provided by EASY Control is
insufficient, simply modify the software setting options on a computer (Windows
PC/notebook) as desired using the MULTIPLEX Launcher via the USB interface.
Alternatively, it is also possible to switch to the "CLASSIC" software version,
which offers a much wider range of functions. The MULTIPLEX Launcher and
the two WINGSTABI software versions are available free of charge along with
possible updates.
32
In principle, WINGSTABI EASY Control can be used in every installation position,
however the standard installation position must be observed for setup without a
PC: "Laying flat", with the servo connections facing the rear. Other positions can
only be selected using the MULTIPLEX Launcher.
The teach-in procedure begins when WINGSTABI EASY Control is started with
inserted jumper at the MSB connection.
IMPORTANT NOTE: All the mixers must be switched off for the teach-in
procedure. This applies in particular to elevator mixing, Combi-Switch
as well as Snap-Flap. Dual-Rate should also be switched off. All the
controllers (trims) at the transmitter must be set to NEUTRAL.
After switching on the transmitter (must be connected to the receiver), eight
teach-in steps are carried out. The model stands on the ground, only the sticks
of the transmitter will be moved. The current step is indicated by the operation
LED flashing green. The number of flashes corresponds to the respective step.
Fast flashing indicates that a step has been completed: green = ok, red =error.
The teach-in procedure informs WINGSTABI EASY Control which servo is ope-
rating which function and which maximum distance it can travel. This results in
special features for V-tail and Delta airplane models.