Lines In The Scanned Image Appear Too Thin Or Discontinuous; Cannot Connect Or Scan To A Destination Folder On The Lan - HP Designjet T1120 SD-MFP Guide De Référence Rapide

the scanner: see
may need to replace the glass: see
Lines in the scanned image appear too thin or
discontinuous
When scanning documents with thin lines such as CAD drawings, a scan resolution
setting of less than 300 dpi can result in disproportionately thin or discontinuous
lines. HP recommends that you set the scan resolution to a minimum of 300 dpi
when scanning CAD drawings and other documents with thin lines. Scanning with
higher resolution lengthens the overall scan time, but it ensures greater image
quality. This issue is not as noticeable when scanning photos and area fills. For
more information on setting the scan resolution, see
on page 17.
The images below help to illustrate the issue:
Figure 4-1
Figure 4-2

Cannot connect or scan to a destination folder on the LAN

Ensure that you have carried out all the following steps in order to connect and scan
to a specific destination folder on the LAN:
1. Make sure your system is set up on the LAN. See
options on page
ENWW
Calibrate the scanner on page
CAD drawing scanned at 150 dpi
CAD drawing scanned at 300 dpi
22.

Lines in the scanned image appear too thin or discontinuous

27. If the problem still persists, you
Replace the scanner glass plate on page
Set the output quality
System setup and
29.
33