HP Designjet T1120 SD-MFP Guide De Référence Rapide page 42

To install a new software version from a PC
The following requirements must apply:
●
Your scan/copy system must be connected and set up (recognized) on the
local network.
●
You need access to a PC that is set up on the network.
●
A Web browser must be installed on the PC.
To install from the CD-ROM:
1. Write down your scan/copy system's IP address. The IP address can be seen
through the Options > Advanced Options > Network dialog.
2. Save the new software installation file on the PC; either from an inserted CD-
ROM, or downloaded from the Internet.
3. Open a Web browser on the PC and enter the scan/copy system IP in the
address field. This will open the scan/copy system's network accessed
Upgrading Scanner Software interface.
4. Use the browse option to locate and select the installation file on the CD-ROM.
5. Install the software. This will upload the software to your scan/copy system.
You can now shut down the PC. The remaining steps take place on the scan/
copy system's touch screen.
6. Press Options > Advanced Options > Software Update to start the Software
Update & Recovery menu.
7. Choose the System Update/Recover option in the Software Update &
Recovery menu.
8. The new program version image you uploaded from the CD-ROM will appear
in the program version image list.
9. Select this image to install it.
10. Select the Return to normal scanner operation button and confirm. The
system will load and initialize all its parameters. Do not turn off the scanner
or interrupt the load process. This step can take up to ten minutes to
complete.
11. At the end of the system load process, you will be asked to calibrate the touch
screen. Press the arrows and OK button when prompted.
12. Select the language for your system software.
13. Accept the HP license agreement.
14. Your system will complete the installation process and start up your scan and
copy program interface.
38 Chapter 4 Troubleshooting ENWW