Honda HSM1180i Manuel De L'utilisateur page 95

SYMPTOM
S n o w d i s c h a r g e
c h ut er d oe s n ot
throw snow well.
Auger runs up onto
and does not cut
into ha r d s now.
A u g e r h o u s i n g
becomes clogged
up with snow.
Auger is in contact
w i t h t h e r o a d
surface.
S n o w b l o w i n g
mechanism makes
an abnormal noise.
S n o w d i s c h a r g e
chuter direction can
not be.
90
POSSIBLE CAUSE
Engine is overloaded.
Engine speed is too low.
Blower changes in shape.
Blower shear bolt is
broken.
Auger shear bolt is broken.
Snow discharge chute is
toward down.
Auger height is not proper.
Auger shear bolt is broken.
Auger is worn.
Blower shear bolt is
broken.
The height of skid and
scraper is not proper.
A u g e r h e i g h t i s n o t
adjusted properly.
Skid and scraper height is
not adjusted properly.
The shape of the shaft and
wing of the auger and/or
blower is deformed.
Fuse is blown out.
M o t o r i s o v e r h e a t e d
(breaker tripped).
Motor or switch or relay is
faulty.
REMEDY
Lower the driving speed (see
page 57).
Move the throttle control lever
to the ''FAST'' position (see
page 47).
Replacement of blower (see
page 75).
Inspection or replacement of
blower shear bolt (see page 35
and 74).
Inspection or replacement of
auger shear bolt (see page 35
and 74).
Ad j u s t s o t h a t t h e s no w
discharge chute is toward up
(see page 48).
Auger height adjustment (see
page 44).
Auger shear bolt check or
replacement (see page 35 and
74).
Auger replacement (see page
75).
Blower shear bolt check or
replacement (see page 35 and
74).
Skid and scraper adjustment
−
(see page 41 43).
Auger height adjustment (see
page 44).
Skid and scraper adjustment
−
(see page 41 43).
Consult an authorized Honda
dealer.
Fuse check or replacement (see
page 76).
Wait for a while. Do not keep
pushing operation lever.
Consult an authorized Honda
dealer.