Honda HSM1180i Manuel De L'utilisateur page 60

Battery run system
Use the battery run system to transport the snowblower in case the
engine does not start.
−
1. Set the main shift lever in the N (neutral) position.
−
2. Release the drive clutch lever to set it in the STOP position.
−
3. Turn the engine switch to the ON position.
−
4. Squeeze the right and left steering levers simultaneously for
approximately 3 seconds.
DRIVE CLUTCH LEVER
STEERING LEVER (left)
−
5. Both the drive control warning indicator (red) and the drive control
warning indicator (orange) blink by squeezing the right and left
steering levers for approximately 3 seconds. Squeeze the drive
clutch lever when the indicators blink.
If the drive clutch lever is not squeezed within 5 seconds after the
drive control warning indicators start to blink, the indicators stop
blinking but they stay on automatically. The battery run system is
automatically disarmed this time, which prevents the snowblower
from running with the battery power.
Return the engine switch to the STOP position and restart the
engine.
DRIVE CONTROL WARNING
INDICATOR (red)
ENGINE SWITCH
STEERING LEVER (right)
DRIVE CONTROL WARNING
INDICATOR (orange)
MAIN SHIFT LEVER
55