Auger housing height
1.
Operate the auger control switch back and forth. The auger housing
height can be adjusted without stages.
To raise: Pull the auger control switch to ''UP''.
To lower: Push the auger control switch to ''DOWN''.
2.
Release the auger control switch, and the auger housing is
secured in the position.
HIGH:
Use this position when clearing the snow in steps and use
it when reversing or transporting the snowblower. (When
the ICS switch is ON, use this position during reversing
the snowblower.)
MIDDLE:
Position for normal clearing. (Use this position to clear
the snow normally.)
LOW:
Position for clearing hardened snow. (Use this position
when the snow you are to clear is hardened and the snow
clearing part of the snowblower tends to get raised.)
44
U
U
P
P
AUGER CONTROL
SWITCH
AUGER HOUSING
D
D
O
O
W
W
N
N
DOWN
UP
HIGH
MIDDLE
LOW