Load Capacity; Tools For Assembling The System Joint - FIOR & GENTZ NEURO LOCK Notice D'utilisation

6.

Load Capacity

The load capacity results from the relevant patient data and can be determined by using the Orthosis Config-
urator. Use the system components determined by the Orthosis Configurator when producing an orthosis and
mind the recommended production technique. You will find information on the production techniques in the
section "Online Tutorials" on our website www.fior-gentz.com.
7.

Tools for Assembling the System Joint

Tools for System Joint Screws
T15 hexalobular screwdriver/bit
T20 hexalobular screwdriver/bit
torque screwdriver 1–6Nm
slotted screwdriver 2 x 0.4mm
slotted screwdriver 2.5 x 0.4mm
slotted screwdriver 3.5 x 0.6mm
Tools for Pan Head Screw for Exchanging the
Extension Stops
T8 hexalobular screwdriver
T10 hexalobular screwdriver
36
System Width
12mm 14mm
x x
- x
x x
x x
x x
x x
System Width
12mm 14mm
x x
- -
16mm 20mm
x -
x x
x x
x x
x x
x x
16mm 20mm
- -
x x