Maintenance
To prevent your leisure battery from becoming totally discharged during long periods of inactivity it
must be disconnected and recharged before using again.
Please check regularly that the rollers of the drive units are free of any dirt, or debris that may have
been picked up during use/during periods of inactivity.
Please check regularly the distance between the rollers and the tyres. In the neutral, fully disengaged
(Fig.4) position this must be 20mm.
When your caravan is stored for an extended period of time (over winter for example) it is
recommended to remove the leisure battery from the caravan. Make sure you keep it charged to
ensure it is in good condition the next time you want to use it.
Once a year have your caravan movers maintained and visually inspected. This inspection must
include all the bolt/nut connections, the cables and electrical connections and lubrication of movable
parts/joints.
It is advised that you regularly check that no wiring connections have come loose across your motor
mover system.
Long periods of inactivity generate the potential for elements of the movers to cease. Deal with this
accordingly by applying lubrication and removing oxidisation where necessary.
DO NOT use any form of pressurised water or chemical cleaning on your caravan movers.
When maintaining your motor mover system, be sure to isolate the electrical supply, failure to
do so could result in electrocution.
In case of any failures or problems, please contact your Caravan Mover supplier.
Troubleshooting
Unit fails to operate or moves intermittently. Possible solutions are:
Handset not connected - Ensure that all home screen items (Fig.17) are solid and not flashing. If
they are then it is likely that the handset has not yet connected. Move closer to the caravan, if the
handset still fails to connect, run through the handset pairing process. Ensure that power is getting to
the electronic control unit (4) before beginning the pairing process.
Handset not turning on - Handset battery could be depleted. If empty, renew using two new 'AA'
1.5V batteries.
Caravan battery empty - Check that the leisure battery is fully charged. Refer to handset display (Fig.
17.D/H)
Caravan battery low - with the rollers engaged. Ensure that when operating the mover that the
leisure battery icon on display (Fig.17.D) remains at atleast 3 bars under load. If the charge indicator is
dropping to 2 or below it may indicate a depleted or damaged battery.
Electronics current limit reached - Allow the mover to sit for 30 seconds, this will allow the
electronics to restart and operation will begin again. If the problem persists call your mover supplier.
52