Optional Fitting Adapters - Carbest CARA-MOVE II Manuel D'utilisation

Optional Fitting Adapters

Additional chassis clamp adapters shown below are available for purchase:
Low Profile Chassis Adapter Plates (Part No. CM-029)
If your chassis frame height is less than 140mm these plates must be fitted to
lower the assembly to provide the correct height of 185mm. Drilling of your
chassis may be required. Note: In some countries, the installation must be
checked by a professional technician in order to adhere to local regulations.
Narrow Gauge Chassis Adapters (Part No. CM-030)
These plates must be utilised if you have an AL-KO Vario III/AV chassis which
has a frame thickness of less than 2.8mm. These must be positioned behind the
axle using pre-drilled holes already available on the chassis; so your mover must
be fitted behind the axle.
16mm Spacers - 1 pair (Part No. CM-028/Q)
Use spacers to lower the mover assembly if your chassis has a frame height of
between 140 to 185mm. A maximum of 3 sets of spacers can be utilised to
achieve correct frame height of 185mm. A set of extended clamp bolts must be
used in conjunction with these spacers (Part No. CM-031).
Set of 8 M10 x 100 Bolts (Part No. CM-031)
Set of 8 extended clamp bolts for use with 16mm spacers.
UK: Photographs & diagrams for illustration purposes only. Actual product may differ slightly. All weights & dimensions are
approximate. The manufacturer reserves the right to change product specification without prior notice. E & OE.
56