Carbest CARA-MOVE II Manuel D'utilisation page 49

Operation - Handset Functions
Fig.17.A = Signal strength
Indicates signal strength between handset and control unit inside the caravan. If a flashing cross is
showing (Fig.17.F) , the handset is not paired to the electronic control unit (4).
Fig.17.B = System status
If a smiling face is showing the system is working correctly. If a magnifying glass is showing (Fig.
17.G), the handset is waiting to pair. If an 'E' number is showing refer to the 'Troubleshooting' Section.
Fig.17.C = Handset Battery Status
Indicates handset battery level in 25% increments.
Fig.17.D = Leisure Battery Status
Indicates voltage level of leisure battery, for maximum performance ensure battery is fully charged and
showing 4 bars before operating mover. If a cross shows (Fig.17.H), the electronic control unit is not
reviving power from a leisure battery.
Fig.17.E = Vehicle Orientation
This shows the direction of travel of the caravan, when the thumbstick is moved the caravan will follow
in this direction. By default the hitch is designated as the forward direction. At any time press the multi-
function button (Fig.10.C) to flip the caravan orientation, the rear of the caravan will then move forward
when the thumb stick is moved upwards.
To access options, press down firmly on the Directional thumbstick (Fig.10.B) and Multi-Function
button (Fig.10.C) for 3 seconds. Use the Directional thumbstick (Fig.10.B) to negotiate the menu,
pressing down to select options. Use the Multi-function button (Fig.10.C) to go back. The following
options are available:
Within the Settings are the following choices:
Axle Mode Selection - By default, handsets are set to single axle mode. If installed as a twin axle or
AWD system this mode should be change. The white dot indicates the selected mode.
Single Axle Mode
2 movers, on the spot
rotation enabled.
Diagnostics
Handset Pairing - Simply press to start pairing process, for more
information on pairing or repairing your handset see the 'Operation -
Handset Pairing' section of this manual.
2 movers, on the spot
Twin Axle Mode
rotation disabled.
47
Settings
AWD Mode
4 movers, on the spot
rotation disabled.