Transport; Troubleshooting; Service Information - Parkside PBS 350 A1 Consignes D'utilisation Et De Sécurité

By properly disposing of this product, you are also contribut-
ing to the effective use of natural resources. You can obtain
information on collection points for waste equipment from
your municipal administration, public waste disposal author-
ity, an authorised body for the disposal of waste electrical
and electronic equipment or your waste disposal company.

14. Transport

The machine must only be lifted and transported on its frame
or the frame plate. Never lift the machine at the safety de-
vices, the adjusting levers, or the sawing table.
During the transport the saw blade protection must be in the
lowest position and near the table.
Never raise at the table! Unplug the machine from the mains
during transport.

15. Troubleshooting

Fault Possible cause
Motor does not work Motor, cable or plug defective, fuses burnt
Housing cover open (limit switch)
The motor starts up Voltage too low, coils damaged, capacitor burnt
slowly and does not
reach operating speed.
Motor makes excessive Coils damaged, motor defective
noise
The motor does not Circuits in the network are overloaded (lamps
reach its full power. other motors, etc.)
Motor overheats easily. Overloading of the motor, insufficient cooling of
the motor
Saw cut is rough or Saw blade dull, tooth shape not appropriate for
wavy the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw blade not
and/or splinters suitable for use
Saw blade is not running a) Guide has been wrongly set
straight
b) Wrong saw blade
Burn marks appear on the a) Blunt saw blade
wood during the cutting b) Wrong saw blade
work
Saw blade jams during a) Blunt saw blade
cutting work b) Deposits on the saw blade
c) Guide has been set poorly

Service information

Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also
required for use as consumables.
Wear parts*: Bandsaw blade, table inserts, Push stick
* Not necessarily included in the scope of delivery!
22 GB/IE
Remedy
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Close housing cover exactly
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a special-
ist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the same
circuit
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Resharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
a) Set the saw blade guide according to the operating
instructions
b) Select a saw blade according to the operating
instructions
a) Change the saw blade
b) Select a saw blade according to the operating
instructions
a) Change the saw blade
b) Clean the saw blade
c) Set the saw blade guide according to the operating
instructions