Wiring - Burkert 8071 Manuel D'utilisation

InstallationandWiring
7.3.

Wiring

danger
risk of injury due to electrical voltage.
• Shut down and isolate the electrical power source before
carrying out work on the system.
• Observe all applicable accident protection and safety regula-
tions for electrical equipment.
• Use a high quality electrical power supply (filtered and
regulated).
• Make sure the installation is equipotential.
red wire
black wire
White wire
yellow wire
Green wire
Table 1: Connection wire assignment
Type 8071
Power supply (+)
Power supply (-)
NPN transistor output
Reed switch
Reed switch
7.3.1. Wiring the npn transistor output and
the reed switch output
L+ (4,5 - 24 V DC)
(red wire)
L- (black wire)
R
NPN transistor out-
put (white wire)
R=1,8 kW pull-up at 24 VDC
Fig. 5: Wiring of NPN transistor output and the Reed switch
output
- +
IN
IN = pulse input on remote transmitter
Remote transmitter
Fig. 6: Example for the connection of the NPN transistor output to
a remote transmitter
English
V DC
yellow wire
green wire
L+
V DC X
L-
NPN
8071
15