The ash pan must be cleaned every 30 days. The frequency depends however on the time of use of the cooker and the type of
pellets used.
To access the pan, open the door (1), unscrew the wing nuts and remove it (2).
N.B.:the operation should be carried out only with the cooker cooled down
1
1
Drawer
ash
Cleaning glass
The glass of the door should be cleaned with the cooker cooled down using a cotton cloth or paper towel.
For stubborn stains we recommend you use a damp (water) cloth and ash collected after burning (which has abrasive properties).
There are special glass cleaning products and appropriate means for cleaning stoves and fireplaces available on the market.
DO NOT SWITCH ON THE STOVE IF YOU NOTICE ANY DAMAGES ON GLASS SURFACE.
Cleaning the internal vermiculite (Firex 600)
The FIREX 600 products stand out due to the fact that they are heat resistant, lightweight and have excellent insulation capacity, with
consequent improvement of combustion and performance of the cooker.
During combustion, the FIREX 600 whitens due to Pyrolysis, making the flame light and bright. Therefore, if combustion is suitably
regulated, the original colour of the internal part of FIREX 600 remains unchanged.
This means that the colour of vermiculite during combustion indicates whether the latter is correct or not:
FIREX 600 LIGHT = OPTIMAL COMBUSTION
FIREX 600 DARK = BAD COMBUSTION
The firex 600 does not require any special maintenance: it must only be cleaned from dust with a brush if you want to remove the
ash built up during combustion.
- You should not use abrasive sponges to clean the more stubborn residues as it could compromise the thickness of the
FIREX 600, creating critical breaking points.
- It is not advisable to use the vacuum cleaner hose in direct contact with FIREX 600.
- It is not advisable to use damp clothes to clean the FIREX 600.
User manual MIA 90
CONTACT THE TECHNICAL SUPPORT SERVICE TO HAVE IT REPLACED.
2
2
Vers. 1 du 20/10/16
EN
Page135