Cleaning Provided By The User - Ravelli MIA 90 Manuel De L'utilisateur

EACH ALARM CAUSES THE IMMEDIATE SWITCHING OFF OF THE STOVE. PRESS THE SWITCH-ON
BUTTON TO RESET THE ALARM. BEFORE SWITCHING ON THE STOVE, MAKE SURE THE
CONDITION THAT CAUSED THE ALARM HAS BEEN RESOLVED.
In the case of alarm 07 THERMAL BREAKER below shows the location where to operate to reset the thermal switch with
manual reset.
Unscrew the protective cap and press
the button to reset the thermal breaker
Cleaning should be provided by the user
Before any cleaning operation on the stove, implement the following precautions:
- switch off the stove and from OFF state, disconnect the power cord;
- make sure all the parts of the stove are cold;
- make sure the ash is completely cooled.
To clean the surfaces of the coated metal parts, use a cloth soaked in water or water and soap.
Attention! Use of abrasive detergents or diluents can damage the surface of the stove.
PLEASE READ CAREFULLY THE FOLLOWING INSTRUCTIONS TO PERFORM PROPER CLEANING.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY LEAD TO MALFUNCTIONS OF THE STOVE.
AUTOMATIC CLEANING SYSTEM
The main feature of this cooker model is the automatic cleaning of the brazier, where combustion takes place. Therefore, it is no
longer necessary to ensure a periodic cleaning of the Brazier or every time you switch on the cooker like for other models that do not
have this system.
Self-cleaning system working (360° rotation)
THE SELF-CLEANING SYSTEM IS ACTIVATED EVERY TIME YOU SWITCH ON THE COOKER (2 ROTATIONS BY DEFAULT) AND
AFTER 6 HOURS (DEFAULT VALUE) OF CONTINUOUS OPERATION. THE SWITCH-OFF AND SWITCH-ON CYCLE OF THE COOKER
DURING THE CLEANING PHASE WITH THE SELF-CLEANING SYSTEM TAKES ABOUT 10 MINUTES. DURING COOKER CLEANING
AND SWITCH-ON PERIOD, HEATING IS GUARANTEED BY THE THERMAL INERTIA OF THE COOKER.
Cleaning the ash pan
Remove the pan from the stove and remove the ash collected; be very careful if the brazier is still hot as this can damage the cleaning
equipment.
Cleaning operations of the stove depend on the quality of the pellets used and the frequency of use.
User manual MIA 90
Manual reset thermal breaker
View the ash pan where the combustion
residue is released by the brazier
The reset thermostat reset button is located on the
right side of the lower compartment. If you open the
storage box you can access the key by unscrewing the
protective cap.
Vers. 1 du 20/10/16
EN
Page134