Loading The Auger; Comfort Climate - Ravelli MIA 90 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour MIA 90:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Loading the auger

Carry out this operation to facilitate cooker's first start operations; you should also check that you have introduced pellets into
the hopper and wait until the cooker is in "SHUTDOWN" or "FINAL CLEANING" mode. The number expressed in seconds
indicates the remaining time of the first loading cycle. Once this time has elapsed, the auger stops automatically and then
you can switch on the appliance.
Below are given the steps for accessing the relative menu.
Menu access
SETTINGS
At the end of the auger loading, the display shows 0 "and automatically switches to the USER menu page.
Press the key for several times until the Stand-by page is displayed.
THE PRESET TIME OF INITIAL LOAD ALSO INCLUDES SUFFICIENT PELLETS TO CARRY OUT THE FIRST IGNITION.
AFTER THE INITIAL LOAD NO BRAZIER CLEANING WILL PRECEDE THE IGNITION PHASE.

Comfort climate

CLIMATE COMFORT function is only active in HEATING mode.
The activation of this function enables the cooker to reduce pellet consumption by activating the modulation phases, after the desired
room temperature has been reached. Subsequently, the cooker checks if the temperature is steady for a set time and if this condition
is met, it automatically switches off and on display appears the word ECO.
The cooker turns on again when the temperature drops below the set threshold (CLIMATE COMFORT DELTA).
Below are given the steps for accessing the relative menu.
Menu access
SETTINGS
THE EXTERNAL THERMOSTAT MUST NOT HAVE VOLTAGE ON THE CONTACTS: MUST BE AN OPEN/CLOSE
CONTACT. WE RECOMMEND YOU USE A THERMOSTAT WITH A MINIMUM OFFSET OF 3°C IF YOU INTEND TO
USE THE COMFORT CLIMA FUNCTION.
User manual MIA 90
Press the key
Look for the option LOAD
"confirm"
to access the
USER page
Press the key
"confirm"
to access the
USER page
Press CONFIRM to enable
AUGER
the rotation of the auger
Press the key "selection" for
several times
to switch to the second page
of USER MENU and select
CLIMATE COMFORT.
Vers. 1 du 20/10/16
EN
Page124

Publicité

Table des Matières
loading

Table des Matières