Safety Information - Ravelli MIA 90 Manuel De L'utilisateur

Safety information

The cooker must be installed and inspected by specialist staff trained by head office. Please carefully read this user and maintenance
manual before installing and operating the cooker. If you require further clarification, contact your nearest Aico SpA dealer.
The cooker must be located indoors, never outdoors. The cooker is controlled by an electronic board that enables completely automatic
and controlled combustion: its controller regulates the switch-on, the levels of
and switch off phase, guaranteeing safe functioning.
Much of the ash falls into the ash pan. There are different types of pellets on the market, not all of the highest quality, and they can
leave residues which are difficult to remove. In stoves without automatic cleaning system, check daily the cleanliness of the brazier.
The glass is equipped with a special air wash for self-cleaning: yet, it is impossible to avoid a slight yellowish film on the glass after
some hours of functioning.
The cooker must be powered by 6 mm diameter pellets.
WARNING
• Prepare the installation location of the cooker according to local, national and European regulations.
• The cooker must only be powered using high quality pellets with a diameter of 6 mm as described in the dedicated chapter.
The stove cannot burn traditional wood.
• It is forbidden to use the cooker as an incinerator. DANGER OF FIRE!!!
• Installation, electrical and hydraulic connection, verification of functioning and maintenance must be carried out by qualified
and authorised staff.
• Improper installation or poor maintenance (non-conformity with what is reported in the following booklet) may cause damage
to people or property. In this condition, Aico SpA is released from all civil or criminal liability.
• Before connecting the cooker to electrical power, the connection of the discharge tubes (specifically for pellet stoves, not in aluminium)
with the flue must be complete.
• The protection grid placed inside the pellet tank must never be removed.
• There must be a sufficient exchange of air in the room in which the cooker is installed.
• Never open the door of the cooker when functioning. FIRE HAZARD!!!
• It is forbidden to operate the cooker with the door open or with the glass broken. DANGER OF FIRE!!!
• When the cooker is working, the surfaces, the glass, the handle and the tubes are very hot: during functioning these parts can only
be touched using adequate protection.
• Do not switch on the cooker without firstly carrying out a daily inspection as described in the MAINTENANCE chapter of this
manual.
• Do not dry clothes on the cooker. Any washing lines or similar must be kept an appropriate distance from the cooker. FIRE
RISK!!!
• Scrupulously follow the maintenance schedule.
• Do not switch off the cooker by disconnecting the electrical mains.
• Do not clean the cooker until the structure and ash are completely cold.
• Carry out all operations in a completely safe and calm manner.
• In case of chimney fire, immediately turn off the cooker via the button on the display to start the final cleaning - WITHOUT
DISCONNECTING IT FROM THE MAINS AND WITHOUT OPERATING THE POWER I/O SWITCH ON THE BACK OF THE COOKER
-and immediately call the Fire department.
• The cooker MUST BE CONNECTED TO AN INDIVIDUAL FLUE.
• The stove must be installed on the floor with an adequate load-bearing capacity. Should the existing floor not comply with the
requirement above, proper measurements must be taken (for instance, the installation of a load distribution plate).
• The chimney must be accessible for cleaning.
Responsibility
By handing over to the end user this manual,
non-compliance with instructions contained in it.
Aico SpA denies all liability deriving from improper use of the cooker, incorrect use by the user, by
and/or repairs and from use of non-original spare parts.
The manufacturer declines all direct and indirect civil and criminal liability due to:
- poor maintenance
- non-compliance with the instructions contained in this manual
- use not complying with safety directives
- installation not complying with the standards in force in the country
- installation by unqualified and untrained staff
- changes and repairs unauthorised by the manufacturer
- use of non-original spare parts
- exceptional events
Spare parts
Exclusively use original spare parts. Do not wait for the components to deteriorate before replacing them. Replace a worn component
before it is completely broken to prevent any accidents due to sudden breakage
controls as described in the dedicated chapter.
User manual MIA 90
Aico SpA denies all liability, both civil and criminal, for accidents arising from
of the components. Carry out periodic maintenance
Vers. 1 du 20/10/16
EN
Page100