Accessories; Important - Reely SKY EXTRA 300 Notice D'emploi

Accessories:

1 Propeller with spinner
2 Brushless electric motor with propeller drive and motor bracket
3 Flight control system
4 Micro-servos
5 Wheel covers
6 Plywood motor mount
7 Wing screw
8 Engine cover attachment
9 Main landing gear cable with wheel and two setting rings, tail landing
gear cable
The following components, which are not included in the contents of the model, are required for assembly and operation:
Assembly:
Soldering gun, cutter, scissors, mini-drill with different bits, screwdriver, Allen key, foil pen, rigid foam adhesive, 5 min. epoxy resin, possibly thixotropic agents
(micro-balloon or cotton flock) for thickening the resin, super glue for rigid foam, sandpaper, Velcro fastener and double-sided adhesive tape.
Warning!
Observe the security notes of the respective manufacturer when using glues and execute the gluing in well aired rooms only.

Important!

Only use super glue suited for rigid foam! Common super glue may dissolve the foam material and damage it!
Operation:
To fly the model you will require a suitable remote control unit with 4 channels, an appropriate 1500mAh LiPo flight battery with the correct plug fittings as well
as 3 servo extension cables.
Figure 2
10 Rudder hinge screws
11 Two cast parts sheets made up of small parts (these are universal construction
elements, thus the construction of the „EXTRA 300" will only require part of
the cast components supplied).
12 Linkage rods (2 x 150 mm, 2 x 240 mm, 1 x elevator attachment and 2 x
aileron linkage with mounting tube)
13 Cockpit mounting (magnet and metal strip)
14 Plastic hinges
15 Wing support rods (780 mm)
33