Check The Seal; Message State Of Charge Li-Ion Battery; Change Of Li-Ion Battery - Titan TA750 Notice D'instructions

7.4. Check the seal

Check your seal. It should look like
that.
If your seal is not similar to the one in
the figure, the welding time may have
been set wrongly. Optimise the seal,
see item 8 (settings).

7.5. Message state of charge Li-Ion battery

During the use it's possible to always view the state of charge of the Li-Ion battery. When the
Li-Ion battery is about to run empty the first LED flash. Charging the Li-Ion battery see item
7.7.
Li-Ion battery
fully charged

7.6. Change of Li-Ion battery

Read and observe the original Bosch-instruction supplied, especially the safety
regulations.
To change the Li-Ion battery (130),
please press the battery release
lever (121) and pull out the Li-Ion
battery upward with your free hand.
TA750
(0001)
Li-Ion battery
half-full
Afterwards plug the charged Li-
Ion battery (130) into the slot
provided till the stop is reached.
H TA750 EU 46/17
Li-Ion battery
low battery!
44 / 98