Seal Quality; Strap Mismatch - Correction - Titan TA 220 Mode D'emploi

7.2.

Seal quality

Seal quality is very important; it can be subjected to a visual inspection.
Best seal
Bad seal
Welding time too short
Bad seal
Welding time too long
7.3.

Strap mismatch - correction

Due to the use of differently thick plastic strap a strap mismatch of upper and lower straps
may occur.
If the mismatch points out to the left (figure 7.3.1), slightly turn
the outer threaded pin to the left and the inner to the right.
If the mismatch points out to the right, i.e. to the inner side of
the tool (figure 7.3.2), slightly turn the outer threaded pin to
the left and the inner to the right.
Repeat both operations until a uniform seal (figure 7.3.3) has
been achieved.
7.3.1
TA 220
7.3.2 7.3.3
H TA 220 EU 37/09
32 / 64