Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.
Adjustments
8.1.
Cutter adjustment
The cutter has to be adjusted for the
respective thickness in the case of
varying strap thickness.
Unscrew the lock nut (l) at the back of
the tool, turn stop screw (h) with an
Allen key,
clockwise
counter clockwise = greater cutting
Fasten lock nut (l) using spanner after adjustment has been completed.
Note
8.2.
Distance between the feed wheel and the gripper plate
The distance between then feed wheel
(d) and the gripper plate (c) is adjusted
to 0.2 mm. The adjusting screw (i) is
located on the lock nut of the transport
rocker (k). Unscrew the lock nut using
the 10 mm open-jawed spanner and
adjust a (i) 0.2 mm gap at the adjusting
screw.
Fasten lock nut after adjustment has
been completed.
Note! The feed wheel and the gripper plate may not come into contact
PKE
= less cutting
depth
depth
! After adjusting there should not be any, or very few, signs of cutting
on the lower strap.
with each other, otherwise both parts will be subject to premature
wear.
H228 EU 21/11
h
e
d
k
n
l
i
31 / 59
Publicité
Chapitres
Table des Matières
