Maintenance & Cleaning; Replacement / Cleaning Of Feed Wheel (91); Replacement / Cleaning Of Gripper Plate, Front (6) - Titan TA750 Notice D'instructions

9. Maintenance & cleaning

9.1. Replacement / cleaning of feed wheel (91)

To replace or clean the feed wheel (91) please proceed as follows:
Loosen the screws (97).
Remove the support feed wheel (506) by
turning it slightly.
Remove the feed wheel (91) from the
gear (90).
Remove the ball bearing (92) from the
feed wheel (91).
Clean the feed wheel (91) by
the use of compressed air.
Check the state of wear of the
teeth from the feed wheel (91),
and replace the feed wheel (91)
when necessary against a new
one.
Reassemble all in reverse order.

9.2. Replacement / cleaning of gripper plate, front (6)

To replace or clean the gripper plate, front (6)
please proceed as follows:
Loosen the screws (8) and remove the
serrated lock washers (7).
Remove the gripper plate, front (6) from the
front by using pointed pliers.
Clean the gripper plate, front (6) by the use
of compressed air.
Check the state of wear of the teeth from
the gripper plate, front (6), and replace the
gripper plate, front (6) when necessary
against a new one.
Reassemble all in reverse order.
TA750
(0001)
Remove the lithium – ion storage battery
before starting maintenance and cleaning.
97 (4x)
H TA750 EU 46/17
90
506
92
101 98 / 99 / 100
6
91
7 (2x)
8 (2x)
50 / 98