Replacement Of Cutter (22); Servo Reset Of The Tool - Titan TA750 Notice D'instructions

9.4. Replacement of cutter (22)

To replace the cutter (22) please proceed as follows:
Loosen the screw (114) and remove the
cutter cover (113).
Loosen the screw (24) and remove the
cutter guide (23).
114
Remove the cutter (22) and replace it
against a new one.
Reassemble all in reverse order.

9.5. Servo reset of the tool

Should the TA750 can't be removed from the strap due to a technical problem, e.g. strap is
clamping during the welding process.
Then please proceed as follows:
Remove and afterwards reinsert the Li-Ion
battery from / to the TA750.
The servo-control runs the TA750 to basic
setting automatically.
Note:
If the TA750 do not perform a RESET please contact the TITAN-Service!
TA750
(0001)
113
H TA750 EU 46/17
24
23
22
22
23
24
52 / 98