Troubleshooting - TOOLCRAFT ST50-D Notice D'emploi

Troubleshooting

With this digital soldering station, you purchased a product built to the state of the
art and operationally safe.
Nevertheless, problems or errors may occur.
For this reason, the following is a description of how you can easily remove possible
malfunctions yourself:
Always observe the safety information!
Error
Soldering tip temperature is
not displayed
No function
Unintelligible characters in
the display or no operation
possible anymore.
Repairs other than those described above must only be carried out
by an authorised specialist.
36
Possible cause
• The temperature is outside of the range that
can be measured
• The soldering gun is not connected.
• The soldering gun is defective.
• Is the main switch lit when switching on?
Fuse replacement
• The processor was subject to interference.
Switch the device off and on again (reset)