TOOLCRAFT ST50-D Notice D'emploi page 25

• Never reach beyond the tangible grip limit of the soldering gun when
working with it. Danger of burns!
• Only solder on non-fl ammable surfaces. Observe adjacent materials,
since they may be damaged by the heat.
• Always put the hot soldering gun into the soldering gun deposit when
not using it.
• If the product or mains cable is damaged, do not touch it. Danger to life
from electric shock!
First switch off the mains voltage for the mains socket to which the
product is connected (switch off the corresponding circuit breaker or
turn out the fuse, then switch off the FI protection switch so that the
mains socket is separated from the mains voltage on all poles).
Do not pull the mains plug from the mains socket by pulling the cable.
Do not use the product anymore, but take it to a specialized workshop
or dispose of it in an environmentally compatible manner.
• Servicing or repair must only be carried out by a specialist.
• Never use the product immediately after it has been taken from a cold
into a warm environment. The condensation generated may destroy
the product. Moreover, there is the risk of a fatal electric shock!
Let the product reach room temperature before connecting and using it.
This may take several hours.
• The following unfavourable conditions are to be avoided at the place of
installation or during transport:
- Dust and fl ammable gases, vapours or solvents.
- strong vibration, impact or blows,
- strong magnetic fi elds such as those near machines or speakers
25