Operating Elements; Explanation Of Symbols - TOOLCRAFT ST50-D Notice D'emploi

The soldering station is built in protection class II (double or increased insulation)
and must only be connected and operated at domestic mains voltage (230 V/AC,
50 Hz).
Soldering work at live parts is not permissible.
Operation under unfavourable ambient conditions is not permitted.
Unfavourable ambient conditions are:
• Dampness or too high humidity
• Dust and fl ammable gases, vapours or solvents.
• strong vibrations
Any use other than described above is not admissible and causes damage to the
product. Additionally, this is connected to dangers, such as short circuit, fi re, electric
shock, etc.
No part of this product must be modifi ed or converted!
Always observe the safety information!

Operating Elements

1 Control switch
2 Heating output display
3 Illuminated display
4 Temperature controller
5 Multifunctional buttons

Explanation of Symbols

This lightning symbol is used when your health is at risk, e.g. through an
electric shock.
This symbol points out particular dangers associated with handling, func-
tion or operation.
The "Hand" symbol indicates special advice and operating information.
22
1 2
I
SET:
TMP:
1
0
POWER
3
170
°C
169
-
2 3
PRESET
5
4
°C
+