Settings In The Secondary Menu; Jog-Mode; Window - Xylem HYDROVAR Smart Manuel Opérateur

7

Settings in the Secondary Menu

Secondary Menu:
INVERTER STOP
ON -> START
PASSWORD
PASSWORD
Note: The password must be entered at each entry!
J O G – MODE
0.0Hz
In the following paragraphs all possible settings are listed (in the display, there
is shown the European default setting).
7.1

JOG-MODE

J O G – MODE
0.0Hz
internal controller of the Hydrovar-Smart will be shut off and the inverter changes to
manual mode. With the buttons
Setting of 0,0 Hz stops the inverter. If the JOG-MODE is left at a frequency higher than 0,0
Hz the inverter will continue its normal automatic operation.
Press on the Hydrovar-Smart to change to
7.2

Window - %

WINDOW
Possible setting: between 0% - 100% of required value.
Press on the Hydrovar-Smart to change to
Important! Before entering the secondary menu, these instructions
have to be read carefully to prevent incorrect settings which could cause
malfunction.
Stop motor by pressing
Press
0000
Set 'Password 0066' by pressing
0066
Confirm by pressing
X.XX Bar menu is shown
Display and Manual Operation Mode
Actual outgoing frequency and actual analogue input
X.XX Bar are shown. By pressing
and
This value indicates the max. variation of the outgoing
5% pressure.
for 3 seconds to change to
and the first window of the sub
you can set any constant speed.
20
(OFF)
or in this menu, the