Xylem HYDROVAR Smart Manuel Opérateur page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.
TOTAL RUN TIME
Press the
button to change to
Note: All changes have to be saved, that they will not be lost in case of shut off
of the power supply !!
10.
11.
These parameters can also be set during operation; To do so, briefly press the button
and repeat steps 1 – 10.
Note: Often shown displays:
12.
INVERTER LOCKED
enable inverter
To start the Hydrovar-Smart, connect these terminals by closing the external release contact
or by using a short-circuit connection!
0000:00
SAVE ???
+
SAVE ???
SAVED
Runtime of the motor.
This time can be reset together with the
Operating hours.
Simultaneously press buttons
appears on the display. After five seconds the
display jumps back to the 1
This message appears when the connection of
terminal X1/4-X1/5 is open (external release contact).
19
and
until...:
st
display.

Publicité

Table des Matières
loading

Table des Matières