Xylem HYDROVAR Smart Manuel Opérateur page 18

2.
MANUAL LOCAL
X.X Hz
If several pumps are connected via the RS-485 interface, you have to set this
parameter on each pump!
Press the button on the Hydrovar-Smart to change to
!! The following displays of the main menu are valid for all selected Modes !!
3. AUTO - START
AUTO-START ON starts the pump automatically after a failure of the power supply.
If AUTO-START is OFF, the Hydrovar-Smart has to be restarted by pressing the buttons
(OFF) and then (ON) after a power supply failure.
If the AUTO-START is OFF, the unit will not start again in cases of a power supply failure or
disconnection. After restarting the following message is shown:
3.1 NO AUTOSTART
disable inverter
To restart the unit, press at first the
Press and the display changes to
Note:
4. E R R O R 1
.........................
Press the button to change to
5. E R R O R 2
.........................
Press the button to change to
6. E R R O R 3
.........................
Press the button to change to
7. E R R O R 4
.........................
Press the button to change to
8. E R R O R 5
.........................
Press the button to change to
Set the desired output frequency with either
X.XX BAR and then briefly press the
Select (ON) with the
ON
All errors are only readable in English language
Here, there is shown the last error
Shows the error before the last error
Shows the error before error 2
Shows the error before error 3
Shows the error before error 4
button or (OFF) with
and then the button for the start.
18
-button.
or
.