Care And Maintenance; Repair Work; Ordering Spare Parts; Disposal And Environmental Protection - Tractel corso PT 0,5 Manuel D'installation Et De Manutention Original

Operation and Installation Manual
Prior to every use
Always check to ensure that the device is in an orderly working
condition before use, see '7.4 Commissioning' on page 8.
Annual safety inspection
The safety inspection must be carried out annually.
The safety inspection may only be undertaken by authorized
maintenance personnel, see '12.1 Authorized maintenance per-
sonnel' on page 9. Depending on the usage conditions (e.g.
operation in an extremely dirty environment), an intermediate
inspection may be necessary.
We recommend that the system is tested in our factory by
TRACTEL Greifzug GmbH.
Contact TRACTEL Greifzug GmbH or your supplier with regards
to this test.

12.3 Care and maintenance

Interval Work
Daily
– Inspect the anchoring
– Check for dirt
– Test the locking brake
Whenever
– Cleaning
necessary
Quarterly –
Visually inspect the side
plates and rollers (for
cracks, deformations)
6-monthly Visual inspections:
– Roller wear
– Rollers' bearings
– Condition of the chain (reel
drive)
– Condition of the support
1 x annu-
– Safety check
ally
EN-10

12.4 Repair work

Changing the chain (push trolley with reel
drive)
See Fig. 8.
Dismantling
–
–
Assembly
–
–
–
–
Implementation

12.5 Ordering spare parts

Operating personnel
Spare parts lists can be obtained from your supplier or directly
from TRACTEL Greifzug GmbH.
The necessary information for placing the order is located on the
Trained person nomi-
nameplates of the individual components, see Fig. 12. Replace
nated by the operator
missing or illegible labels immediately.
Trained person nomi-
nated by the operator
13
Trained person nomi-
nated by the operator
The equipment is made from recyclable materials. If the equip-
ment is later scrapped, it must be disposed of correctly. The
national versions of the waste legislation directive 2008/98/EC
apply within the European Union.
The manufacturer is obliged to take back and dispose of specific
Authorized mainte-
nance personnel
electrical and electronic components in accordance with Directive
2002/96/EC. The following symbol is used on the nameplate of
such components to identify them:
Open the locking link (4).
Turn the chainwheel (2) until the chain runs completely out.
Place the end of the chain (1) on the chainwheel (2).
The welded seam in the chain links must point outwards.
Turn the chainwheel (2) until the chain hangs freely beneath
the chain guard (3).
Use the locking link (4) to joint the ends of the chain togeth-
er.
Close the locking link (4).
You must ensure that the chain has not turned around.
Disposal and environmental
protection
G941.6 - 10/2017