Safety Instructions; Compulsary Inspections And Checks; Storage And Maintenance - Tractel D039E Notice D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Use with a single operator.

Never exceed a 40 kg load – compact and safe loads.

Ensure good conditions of used rope (Ø 22/30mm).

Control good positioning of the upper hook safety latch.

Ensure anchorage location of the pulley accepts 80 kg.

All maintenance inspections and operations must be performed by qualified specialists.

Check on start-up (or starting back up): in compliance with the national regulations.

Compulsory periodical check in compliance with the national regulations. Recommended every 12

months by TRACTEL SOLUTIONS SAS.

A thorough examination paying particular attention to any alteration of parts due to an impact,

corrosion, cracking or deformation must be conducted at least twice a year, and every month in the

case of heavy-duty use or in an aggressive atmosphere.

TRACTEL SOLUTIONS SAS is at your disposal in order to conduct any regulatory check.

Before each use

Visually inspect all pulley components.

Control location and condition of safety latch.

Check for wobble and excessive clearance in the sheave and free rotation before each use.

Complete inspection

According to French regulation, pulleys used in manufacturing, must be checked each year. This

annual control must include all necessary examinations in order to detect any damage or potential

problems that could cause dangerous situations.

Check if equipment doesn't have any deformation, fissures or other defaults. If upper hooking ring

has more than 10 % wear, the pulley must be replaced.

Check for excessive backlash and wear

Verify groove of the sheave for wear and tear

Ensure that there are no cracks on the welded sleeve and no deformation on the hook latch, proper

fit and operation.

Inspection of the suspension : check for the latch, no deformation of the flanges and the hook,

Check presence and legibility of signalling plate.

Note all controlled information on a register.

Storage

It is advisable to remove the rope from the pulley for its storage. Correctly store the instructions for

use with the pulley. Keep the material in a dry place, protected from bad weather.

Ensure that the pulley is stored with no loads attached.

Functioning anomalies

The sheave rotation must be free

No wobble and excessive clearance in the sheave.

Maintenance of the equipment

All maintenance inspections and operations must be performed by qualified specialists.

Any part with a defect must be replaced by a TRACTEL SOLUTIONS SAS genuine part.

Any deformed equipment must be immediately withdrawn from use.

M 6075 M

rev 4 – 17/02/2014