Components / Modules; Technical Specifications; Anchoring; Safety Equipment - Tractel corso PT 0,5 Manuel D'installation Et De Manutention Original

Operation and Installation Manual
4.2

Components / Modules

See Fig. 2.
Item Name
1 Side plate with runners
2 Side plate with runners and chain wheel
3 Threaded load bolts with suspension eyes
4 Chain
5 Control crank handle
6 Copper disc
7 Threaded pin
8 Locking brake
Allen-key (no picture)
4.3

Technical Specifications

The technical specifications are listed in Table 1 on page II.
4.4

Anchoring

The push trolleys are attached to the supports using '' or 'H'
profiles.
– Note the profile size permitted for the respective push trol-
ley, see table Table 1 on page II.
– Ensure that the support maximum decline of 0.3 % (3 mm
per metre) is not exceeded.
– Observe the maximum working load, see Table 1 on page II.
See also '7.3 Assembly' on page 7.
4.5

Safety equipment

The push trolleys are fitted with mechanical safety devices
against derailing and tipping.
EN-6
4.6

Load limits

See Table 1 on page II.
DANGER!
Incorrect anchoring! Incorrect usage!
Risk of being injured by falling objects!
The load on the deflection roller, rigging and the anchoring
point increases depending on the arrangement of the hoisting
gear, deflection roller and load!
– The support's minimum breaking strength rating must
exceed the hoisting gear's maximum working load by
fourfold for the given installation situation (see Fig. 11
pictures 'a' and 'b').
– If the lifting equipment is attached directly to the anchor-
ing point (see Fig. 11), the deadweight of all of the line
components and the dynamic rate of strain of the hoisting
gear drive system must be taken into account.
– Hoisting at an angle is forbidden!
5

Optional accessories

The following accessories can also be purchased:
 tirak™ motor-driven wire rope hoist
 greifzug™ hand-operated multi-purpose cable hoist
minifor™ motorized cable hoist

tralift™ TE electrical chain hoist

bravo™ lever hoist

tralift™ pulley block

Deflection rollers, adapter

Please directly contact TRACTEL Greifzug GmbH.
6

Necessary accessories

The following accessories, which are not part of scope of deliv-
ery, are necessary to use the product:
 Rigging and securing equipment with an adequate minimum
breaking strength (see 'Structural requirements' on Page 5).
 Manual or electrical hoisting gear
Other original Greifzug accessories: See '5 Optional accessories'
on page 6.
The operator or the manufacturer of the system is responsible for
selecting and using the accessories in accordance with the local
conditions. You must also abide by any other requirements of the
respectively applicable regulations and standards.
G941.6 - 10/2017