Repair And Warranty - Megger SCITS100 Mode D'emploi

Repair and Warranty

The instrument circuit contains static sensitive devices, and care must be taken in handling the printed circuit board.
If the protection of an instrument has been impaired it should not be used, and be sent for repair by suitably trained
and qualified personnel. The protection is likely to be impaired if, for example, the instrument shows visible damage,
fails to perform the intended measurements, has been subjected to prolonged storage under unfavourable
conditions, or has been exposed to severe transport stresses.
New Instruments are Guaranteed for 1 Year from the Date of Purchase by the User.
Note: Any unauthorized repair or adjustment will automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger instruments contact:–
Megger Limited
Archcliffe Road
Dover
Kent CT17 9EN
England
Tel: +44 (0) 1304 502243
Fax: +44 (0) 1304 207342
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been approved for repair work on most Megger
instruments, using genuine Megger spare parts. Consult the Appointed Distributor/Agent regarding spare parts,
repair facilities and advice on the best course of action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent, freight pre-paid, to the appropriate address.
A copy of the Invoice and of the packing note should be sent simultaneously by airmail to expedite clearance through
Customs. A repair estimate showing freight return and other charges will be submitted to the sender, if required,
before work on the instrument commences.
32
or Megger
Valley Forge Corporate Center
2621 Van Buren Avenue
Norristown, PA 19403
U.S.A.
Tel: +1 (610) 676-8579
Fax: +1 (610) 676-8625