Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.3.
Positioning the adjusting pin as a function of the effort in the wire rope
GB
Important remarks
-
Before loading and if no pre-adjustment has been made in the factory, unscrew the
adjustment screw at the most, because you risk to destroy the transducer.
-
To select pin and bracket position, load has priority over wire rope diameter.
-
Never remove the locking nut (G) because tare screw (F) could damage the microswitch.
4
Figure 2
dynasafe™ Mecha 7
For wire rope of 17mm
diameter and for loads
ranging from 300 kg to
2300 kg.
For wire rope from 18mm
to 22mm diameter and
for loads ranging from
350 kg to 5000 kg.
For wire rope from 22mm
to 26mm diameter and
for loads ranging from
500 kg to 7000 kg.
dynasafe™ Mecha 12
For loads ranging from
1000kg to 4000kg.
For loads ranging from
1000 kg to 8000kg.
For loads ranging from
1000 kg to 12000 kg.
For wire rope between
24 to 34mm.
Publicité
Chapitres
Table des Matières
