Festo KSK Notice D'utilisation page 22

KSK
5.1 Preparing for installation
(only for KSK in combination with toothed-belt axes EGC/ELGA)
1. Remove the sealing disc 8 from the desired connection side
(e. g. with a screwdriver).
2. Push the slide into the end position, in which the hollow shaft is
prevented from turning when the drive shaft is tightened.
3. Push the drive shaft provided as far as possible into the hollow
shaft of the EGC/ELGA. The tightening torque is summarised in
the following table.
• Please note that excessive tightening torques can damage the
EGC/ELGA.
Size
Tightening torque EGC
Tightening torque ELGA
1) KSK-185 is intended for ELGA-TB-KF-150
Tab. 1
For KSK-185:
• Push the plugs 4 provided for tube clamping as far as possible in both ends of the connecting
shaft.
5.2 Implementing installation (for all KSK)
• Unscrew the coupling screws of the divided half shells.
• Clean the contact surfaces of the coupling, the drive shaft and
the connecting shaft.
These will only function if they are free of oil and grease.
• Push the couplings each with the undivided hub as far as pos­
sible onto the drive shafts of the axes.
• Only tighten the coupling screws lightly at first to secure the
coupling.
22
50 70
[Nm] 1 1.5
[Nm] – –
8
Fig. 14
Fig. 15
A-70 80 120
– 7 14
7 8.5 14
Fig. 16
Fig. 17
Festo – KSK – 1503d English
1)
185
60
60