Festo KSK Notice D'utilisation page 20

KSK
• Make sure that the permissible radial offset Kr is not ex­
ceeded.
The maximum permissible radial offset (Kr) that can be com­
pensated by the bellows couplings is greater the smaller the
misalignment between the two axes is.
The dependency of the two variables is shown in Fig. 22 in the
chapter "Characteristic curves".
• Compare the outer diameter of the coupling with the available
fitting space.
The couplings may project over the contour of the toothed belt
axis depending on the size-length combination.
• Please observe the instructions for mounting and support spa­
cing in the operating instructions supplied with the axis.
For EGC:
Note
The asymmetrical product geometry of the EGC can
lead to mounting faults.
• Please observe the different distances (LH and
LV) between the centre of the guide and the front
and rear cover surfaces. Connection is possible
at all four hollow shaft ends.
For EGC-...-TB-KF-...-Z with shortened hollow shafts:
Note
• Please note that the drive shaft can only be fitted
on the front for type EGC-...-TB-KF-...-Z.
20
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Festo – KSK – 1503d English