Programming Additional Features - Reely Big1 Notice D'emploi

b) Programming additional features
By default, the speed controller is preprogrammed with the optimal settings.
When using LiPo rechargeable batteries to operate the vehicle, check whether low voltage protection is
enabled in the default setting of the speed controller (normally 3.0 V per cell). When low voltage detection
is disabled, LiPo rechargeable batteries are subject to a deep discharge that destroys them.
The setup button can be used to program the settings.
Proceed as follows:
• Switch on the remote control.
• Switch off the speed controller (move the switch to the "OFF" position).
• Hold down the setup button (B) next to the on/off switch (A) and turn on the speed controller (move the switch to
the "ON" position).
Keep holding down the setup button (B).
• The red LED on the speed controller will flash and the engine will emit beeps (keep holding down the setup button).
• After a while, the green LED will flash (keep holding down the setup button) and the engine will emit beeps. This
indicates which setup function is currently selected.
Green LED flashes once briefly and one short beep is emitted: Forward/reverse throttle or forward throttle only
Green LED flashes twice briefly and two short beeps are emitted: Brake
Green LED flashes briefly three times and three short beeps are emitted: Low voltage detection for the LiPo battery
Green LED flashes briefly four times and four short beeps are emitted: Startup mode
Green LED flashes briefly five times and five short beeps are emitted: Braking power
Beeps are generated by a brief activation of the brushless engine. This beep can be very quiet depending
on the engine. Note the LED indication on the speed controller.
• When the desired setup function is displayed (for example, for low voltage protection, the green LED flashes briefly
three times and the engine emits three short beeps), release the setup button.
• Now the red LED will flash. The number of red flashing signals indicates which setting value is active (for example,
for 3.0 V per cell low voltage protection , the red LED flashes briefly four times and the engine emits four short
beeps).
• Briefly press the setup button to change the setting value; the number of flashing signals from the red LED (and
engine beeps) will change accordingly (see table on the next page).
• Turn off the speed controller to exit settings mode and save the programming. If you then turn on the speed control-
ler, it will be ready for operation with the new settings.
• Follow the above steps to change the other settings.
49