Stihl FS 38 Notice D'emploi page 31

English
1
2
3
Removing Remaining Nylon Line
In normal operation the line supply
in the mowing head is used up
completely.
Disassembling the mowing head
To remove residue of line:
: Hold the mowing head steady and
rotate the cap (1) counterclockwise
until it can be removed.
: Pull the spool (2) out of the mowing
head (3) and remove the remaining
line.
30
4
2
Assembling the mowing head
: Fit the empty spool in the mowing
head.
: If the spring (4) has popped out,
push it into the spool (2) until it
engages in position with an audible
click.
: Mount the mowing head as
described in chapter "Mounting
Cutting Tools" / "Mounting the
Mowing Head" / "STIHL AutoCut C
5-2".
3
2
3
5
Winding Line onto Spool
: Use nylon line with a diameter of
2.0 mm (green).
: Cut two 2 m lengths of line from the
replacement reel.**
: Rotate the spool (2) counter-
clockwise until the two arrow points
are in alignment.
: Push the straight end of each line
through one sleeve (5) in the
mowing head (3) until a noticeable
resistance – and then continue
pushing as far as stop.
** See "Special Accessories"
FS 38