Stihl FS 38 Notice D'emploi page 24

: Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope all
the way – it might otherwise break.
: Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
FS 38
8
: Crank the engine until it fires. After
no more than five pulls, move the
choke lever (8) to e
: Continue cranking.
As soon as the engine runs
: Squeeze the throttle trigger to
disengage the tongue, then release
the trigger – the engine settles down
to idle speed.
Make sure the carburetor is
correctly adjusted – the cutting tool
must not rotate when the engine is
idling.
Your brushcutter is now ready for
operation.
To stop the engine
: Move the stop switch to O
If the engine does not start
Choke lever
If you did not move the choke lever to e
quickly enough after the engine began to
fire, the combustion chamber is flooded.
Move the choke lever to e
:
: Set the stop switch to I, move the
throttle trigger lock and throttle
trigger to the starting throttle
position.
: Start the engine – 10 to 20 strong
pulls may be necessary.
If the engine still does not start
10
: Move the stop switch to O
: Pull off the spark plug boot (10).
English
23