Rewind Starter; Storing The Machine; Replacing The Nylon Line - Stihl FS 38 Notice D'emploi

Masquer les pouces Voir aussi pour FS 38:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Rewind Starter

To help prolong the wear life of the
starter rope, observe the following
points:
:
Pull the starter rope only in the
direction specified.
:
Do not pull the rope over the edge of
the guide bushing.
:
Do not pull out the rope more than
specified since it might break.
:
Do not let the starter grip snap back,
guide it slowly into the housing.
See also chapter "Starting /
Stopping the Engine"!
Replace a damaged starter rope in
good time or have it replaced by your
STIHL dealer!
FS 38

Storing the Machine

For periods of about 3 months or longer
:
Drain and clean the fuel tank in a
well ventilated area.
:
Dispose fuel properly in accordance
with local environmental
requirements.
:
Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
:
Remove, clean and inspect the
cutting tool.
:
Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
:
Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.

Replacing the Nylon Line

STIHL AutoCut C 5-2
Always inspect the mowing head for
signs of wear before replacing the nylon
line.
A mowing head with signs of severe
wear must be replaced as a
complete unit.
Preparartions
:
Shut off the engine.
:
Lay your trimmer on its back with
the mowing head facing up.
English
29

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Table des Matières