Balancing The Trimmer/Brushcutter - Stihl FS 260 C Notice D'emploi

English
FS 360 C
2
3
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the spring hook to the
N
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Machine".
26
Balancing the
Trimmer/Brushcutter
The type and style of the harness and
carabiner (spring hook) depend on the
1
market.
FS 260 C
Attaching the unit to the harness
2
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
Floating positions
Mowing heads, grass cutting blades and
brush knives and shredder blades
should just touch the ground.
2
1
1
Circular saw blades should "hover"
about 20 cm above the ground.
The correct floating position is obtained
as follows:
Balance the unit
3
2
Loosen the screw (3).
N
Move the carrying ring (2) up or
N
down the drive tube – tighten the
screw moderately – let the unit go
and wait until is its balanced – then
check the floating position.
When the correct floating position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
FS 260 C, FS 360 C