Stihl FS 260 C Notice D'emploi page 23

Removing the Cutting Attachment
Block the drive shaft.
N
Unscrew the mounting nut
N
clockwise.
If the mounting nut turns too freely, fit a
new one.
Mounting Circular Saw Blades
A limit stop kit, which includes a limit
stop and a guard ring for circular saw
blades, is available as a special
accessory for mounting circular saw
blades.
Note on new machines that come
standard with a mowing head only:
Further mounting hardware is necessary
for a circular saw blade. It is available
from your servicing dealer.
The cutting edges of circular saw blades
must point clockwise.
Changing the guard ring
Recommendation: The guard ring must
be mounted with particular care. Have
this work performed by your dealer.
STIHL recommends a STIHL servicing
dealer.
FS 260 C, FS 360 C
1
2
3
Remove the guard washer (1) and
N
thrust plate (2).
Remove the guard ring (3) for
N
mowing attachments.
Keep the guard washer and guard
N
ring in a safe place for future use.
2
4
Fit the guard ring (4) for saw blades.
N
Slip the thrust plate (2) over the
N
shaft.
Fit the limit stop (5) for circular saw
N
blades.
Do not use the guard washer (1) with
circular saw blades.
Mounting the Cutting Attachment
4
2
b
a
5
Place the cutting attachment (1) in
N
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Fit the thrust washer (2) – convex
N
side must face up.
Fit the rider plate (3).
N
A rider plate (3) for sawing applications
is available as a special accessory. It
allows the full depth of cut of the saw
blade to be used.
Block the drive shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
English
3
1
21