Stihl FS 260 C Notice D'emploi page 16

English
5
6
2
7
Line up the control handle (5)
N
relative to the handlebar (2): The
throttle trigger (6) must point toward
the gearbox and the clamp
screw (7) toward the engine.
14
8
2
5
4
8
Holding the control handle (5) in
N
that position, push it on to the end of
the handlebar (2) and line up the
holes (8).
Fit the nut (4) in the control
N
handle (5), insert the screw (3) and
tighten it down firmly.
Assembling the handle support
Assembly of the swivelling handle
support involves equipping the clamp
moldings with a spring and mounting
them on the handle support.
Use the spring (9) from the parts kit
N
supplied with the machine.
Place the spring (9) in the lower
N
clamp molding (10).
3
1
2
Position the clamp moldings (1) with
N
handlebar (2) on the handle
support (11).
9
10
A
11
FS 260 C, FS 360 C