Bevel Ripping; Maintenance; Changing The Blade - Evolution FURY5-S Instructions D'origine

www.evolutionpowertools.com
the saw. The operators left hand will be to the LH side of the
saw blade. The operators right hand will be close to the rip
fence on the RH side of the sawblade.
WARNING: The operators hands should never be in line with
the blade.

BEVEL RIPPING

Bevel ripping is cutting along the length of a work-piece with
the saw blade tilted at an angle.
When bevel ripping material 150mm or narrower use the
rip fence on the RH side of the blade only. (Fig 42)

MAINTENANCE

WARNING: Ensure that the machine is disconnected from the
mains supply before any maintenance tasks or adjustments
are attempted.

CHANGING THE BLADE

Note: We recommend that the operator considers wearing
protective gloves when handling or changing the machines blade.
• Disconnect the machine from the power supply
• Remove the top blade guard. (refer to TOP BLADE GUARD
on page 18)
• Remove the table access plate by removing the countersunk
head screw from the front edge of the access plate. (Fig. 43)
• Lift the plate away and carefully store it and its fixing screw
for future use.
• Raise the blade to its highest position.
• Use the two blade changing spanners provided. One spanner
will fit the hexagonal nut machined onto the outer blade
flange, and thus prevent the arbor from rotating. The other
spanner will fit the arbor nut. (Fig 44)
• Remove the arbor nut, the outer blade flange and the blade.
• Thoroughly clean any debris from these parts and also from
the exposed motor arbor and inner blade flange. The inner
blade flange can be left in situ.
• Fit the new blade. Ensure that the teeth are facing to the
front of the saw (Fig. 45), and that the rotation arrow on
the blade is in conformism with the rotation arrow on the
motor housing.
• Replace the outer flange and nut and tighten securely with
Fig. 42
Fig. 43
Fig. 44
Fig. 45
25
EN
DE
FR
NL