Dual Read Scale; Mitre Gauge - Evolution FURY5-S Instructions D'origine

Masquer les pouces Voir aussi pour FURY5-S:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

www.evolutionpowertools.com
Forwards and backwards adjustment of the rip fence faceplate
(Fig. 28) is possible. Loosen the two wing nuts and slide the
aluminium faceplate to the desired position. Tighten the wing
nuts securely.
Note: We recommend that normally the rip fence faceplate be
adjusted so that the rear of the faceplate guide is 'in line' with
the rear of the blade where it emerges from the table. (Fig. 29)
Note: If the rip fence is used on the LH (left hand) side of the
blade, the aluminium faceplate will have to be repositioned
to the RH (right hand) side of the plastic carrier.
• Loosen the two wing nuts and slide the aluminium
faceplate from the plastic carrier.
• Remove the dome headed machine screws from the carrier.
• Reposition the faceplate to the RH side of the carrier and
re-attach using the machine screws and the wing nuts.
Adjust as necessary.
Return to the original configuration when the rip fence is in
the normal (RH) operating position.
THE DUAL READ SCALE
Note: The rip fence guide incorporates a viewing window to
aid reading the measurement scale found on the fence rail.
(Fig. 30). The scale should be regarded as a useful guide. It is
not a substitute for careful and accurate 'marking out'.
This machine has a dual read scale that shows the distance
from the blade to the rip fence through the viewing window.
This can be used to aid setting the cutting distance from the
blade to the rip fence. With the rip fence faceplate attached by
its shorter side, use the black scale to set the distance of the
rip fence. When the faceplate is attached by its longer side, use
the green scale.

MITRE GAUGE

Note: The mitre gauge (K) (Fig. 31) can be used on either side
of the table and runs in either of the two inverted 'T' slots in
the table top.
Carefully slide the mitre gauge into the required slot in the
table top.
Fig. 28
Fig. 29
Fig. 30
Fig. 31
21
EN
DE
FR
NL

Publicité

Table des Matières
loading

Table des Matières