Top Blade Guard - Evolution FURY5-S Instructions D'origine

Fig. 17
Fig. 18
Fig. 19
Fig. 20
Note: It is recommended that the anti-bounce device is fitted
only when needed (e.g. when cutting thin sheet material or
thin walled metal tube etc). At other times safely store the
device off the machine.
The pillar of the anti-bounce device fits into the socket in the
mitre gauge base, and is held in place by a thumb screw. (Fig 17)

TOP BLADE GUARD

The top blade guard (H) (Fig. 18) (sometimes referred to as
a crown guard) must always be fitted to the machines riving
knife. The 'split' line along the top of the guard indicates the
centre line of the saw blade below. Graphics on the guard
further reinforce the cutting line of the saw blade.
WARNING: The top blade guard must be fitted to the
machines riving knife.
WARNING: The machine must be disconnected from the
mains supply when installing the blade guard.
• Raise the blade to its full height to fully reveal the riving
knife. (Fig. 19)
• The guards locating pin should be positioned through the
hole machined in the top edge of the riving knife (Fig. 20).
A washer and wing nut are fitted to one side of the top
guard.
Note: Adjust the blade guard for the material you are cutting.
To adjust to the thickness of the material being cut, the blade
guard must pivot up and down easily and smoothly, so do not
over-tighten this wing nut.
• Check the operation of the blade guard. Ensure that it is
working efficiently and covers the blade at the sides as well
as the crown.
• Lower the blade a little and recheck that the blade guard
operation.
• When satisfied that the blade guard works throughout
the blades height adjustment range, check that the guard
works equally well with the blade set to a bevel angle.
• Check that when the blade is fully lowered, the blade guard
is in contact with the table top.
18
www.evolutionpowertools.com