Anti-Bounce Device; Basic Table Saw Operations - Evolution FURY5-S Instructions D'origine

Fig. 32
Fig. 33
Fig. 34
Fig. 35
Turn the vertical handle counter-clockwise to unlock the mitre
gauge, and adjust to the required angle. Turn the handle clockwise
to lock the mitre gauge at the chosen angle. (Fig. 32)
Note: The extruded aluminium faceplate of the mitre gauge
should be adjusted so that it passes close to, but does not
touch the blade or blade guard. Adjust the faceplate by
loosening the two wing nuts (Fig. 33) and slide the faceplate
to the required position. Securely tighten the wing nuts.
WARNING: Conduct a 'dry run' with the machine
disconnected from the mains supply to ensure that the mitre
gauge does indeed slide passed the blade and blade guard
without any interference.

ANTI-BOUNCE DEVICE

Note: When cutting thin sheet or similar material the
anti-bounce device can be usefully employed. (Fig 34)
Insert the anti-bounce device into the socket provided in the
mitre gauge. Position the anti-bounce device for optimum
efficiency and secure in place using the thumb screws.
Adjust the anti-bounce device so that the head does not quite
touch the material to be cut. You can achieve this by gently
clamping the material to be cut with the anti-bounce device,
and then backing off the head by 1/2 to 1 turn.

BASIC TABLE SAW OPERATIONS

WARNING: Never attempt freehand cuts on this machine.
Always use the appropriate guide or fence to minimise the
possibility of the blade binding and/or kickback occurring.
We recommend that the saw blade protrudes through the
material to be cut by approximately 3mm. (Fig. 35) Adjust the
height of the blade accordingly.
WARNING: This machine is not suitable for cutting rebates
or stopped grooves.
A workshop dust extraction machine can be connected to the
extraction port found at the rear of the machine if required.
22
www.evolutionpowertools.com