Atlantic CALYPSO Notice D'utilisation page 105

Warnings
9. Menu
9.1. Consumption
This menu displays:
• the energy consumption in kWh for hot water production, for the current month, the previous
month, the current year and the previous year since commissioning;
• the percentage of heat pump operation.
Note that if the time and date are not set the energy consumption will not be recorded.
9.2. Absence
This menu can be used to programme an absence:
- permanent from the date
- scheduled (set the absence start and end dates). The night before you return, an anti-Legionella
cycle will be started (only for absences of more than 2 days).
During this absence period, the water temperature will be kept above 15°C.
This function can be interrupted at any time.
9.3. Boost
This function:
• is used to occasionally increase the production of hot water (1 heating cycle);
• can be configured over several days (up to 7).
The heat pump and electric backup are switched on simultaneously. Boost mode take priority over the
other modes. When the set period expires, the water heater will return to its normal mode.
9.4. Setpoint management
This function is used to select ECO+ mode or manual mode (see section "9. Operating modes",
page"10. Operating modes", page 107)
This mode can also be used to manually change the setpoint.
9.5. Parameters
9.5.1. Language
This menu is used to select the display language
Installation Use
105 105