Burkert 8624-2 Standard Instructions De Service page 26

Fig.: Setting the sensor input
The decimal point is set during the setting of S LO. It then applies for the values S
LO, S HI, SET, EXLO, EXHI and cannot be changed within these menu items.
NOTE
Error messages in the menu SENS
24 - 8624-2 Standard
If the sensor scaling is changed, then the setpoint scaling ( EXLO,
EXHI ) is automatically overwritten with values of the sensor
scaling. The internal setpoint ( SET ) is set to S LO.
If the value for S HI was selected lower than that for
S LO or equal to it, the texts SENS and ERR9 appear
flashing alternately on the text display.
In this chase the newly set values are not stored!
increase digit
next digit
2 s
set decimal point
increase digit
next digit