Télécharger Imprimer la page

Stihl AR 1000 Notice D'emploi page 13

Masquer les pouces Voir aussi pour AR 1000:

Publicité

9 LED Diagnostics and Acoustic Signals
9 LED Diagnostics and Acoustic Signals
9.1
Battery Status
Six LEDs and an acoustic signal indicate the status of the
battery. These LEDs can glow or flash green or red.
1
2
3
1 A short beep
This means that the acoustic signal works as it should.
2 Four long beeps
This means that the battery's state of charge is low.
Recharge the battery.
3 Rapid succession of short beeps
This means that there is a malfunction in the battery. The
Signal stops automatically after a few seconds.
If one LED glows red continuously: the battery is
either too hot or too cold. Allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
If the four right side LEDs flash red and a rapid
succession of several short beeps is emitted: the
battery has a malfunction and must be replaced.
Do not attempt to charge, use or store the
battery.
0458-794-8221-C
All manuals and user guides at all-guides.com
► The battery is equipped with a visual and acoustic signal.
9.2
When the battery is connected to the power tool, the same
LEDs on the battery will indicate the status of the power tool.
If three LEDs glow red continuously: the power tool motor is
too hot. Allow the motor to cool down.
If three LEDs flash red when you activate the trigger switch:
the power tool has an electrical malfunction. Do not operate
the power tool. Have it checked by an authorized STIHL
servicing dealer before use or storage.
For troubleshooting information, @ 19. For more
.......
information about transporting a malfunctioning battery, see
@ 15.
9.3
The LEDs and acoustic signals on the battery also indicate
the battery's state of charge.
To determine the battery's state of charge:
► Press the button (1) on the backpack battery.
For example:
If six green LEDs glow continuously: full charge.
Be aware that your ability to hear the acoustic signal may
be reduced when wearing hearing protection.
Power Tool Status
Charge Status
A single short beep will be emitted. The LEDs on the
battery will glow or flash green for about 5 seconds and
indicate the state of charge (see illustration).
English
100 %
0 %
11

Publicité

loading

Ce manuel est également adapté pour:

Ar 2000Ar 3000