Normal Operation / Production Cycle - molex UP 60 Mode D'emploi

UP 60
10

Normal Operation / Production Cycle

DANGER!
 Due to the risk of hand or finger injury, never try to reach into the machine before
having assured that the machine is disconnected from the air supply. Disconnect
the air supply before changing the safety guard, the adapter or the dies.
CAUTION!
 The pneumatic Universal Crimp Machine UP 60 may only be set up and operated in
perfect technical condition, observing all the safety regulations and considering
any possible dangers.
 The crimp machine is only allowed to be used with mounted dies, die adapter and
the suitable safety guard. Pay attention to the correct assignment of adapter to
safety guard.
 Before commissioning the machine, it is always important to check whether all
safety devices, especially the safety guards and die adapter, are installed and are
functioning correctly.
 When working with the pneumatic Universal Crimp Machine UP 60, do not wear
loose clothing, jewellery or long, loose hair that can get caught in the pneumatic
Universal Crimp Machine UP 60.
 Work with caution.
 In cases of a machine malfunction, production must be stopped and the
malfunction must be fixed before continuing work with the machine.
 Only one person is allowed to work on or with the machine.
 Only trained personal are allowed to work on or with the machine.
 Assure free access to the operating elements of the machine, especially the foot
pedal and the release button. In the case of imminent danger immediately press the
release button. The release button must be within the direct reach of the operator. It
must not be covered.
 It is only allowed to work with the specified working pressure.
ATTENTION!
 Position the pneumatic Universal Crimp Machines UP 60 on a flat surface and
assure the stability of the machine. Ensure that the table or bench is stable enough
to support the machine in normal use. During the utilization the machine has to be
placed on a table or a similar flat surface.
 Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
movable, so that the operator has the possibility to change his position for
ergonomic and production needs. Do not lay the foot pedal in aisles or walk ways.
 Place the tubes on the floor so that they do not cause a trip hazard.
1. Insert the crimp contact in the die profile.
2. Insert the wire/cable in position for crimping.
3. Press the foot pedal to start the crimp process.
4. Keep the foot pedal pressed until the crimp cycle is finished.
5. Remove crimped contact.
Page 57 / 104
TM-638018900 REV. B